No products were found matching your selection.
Other Related Products
-


- Material: Closed-cell neoprene foam
- Color: Black as standard
- Adhesive: Rubber PSA or acrylic PSA
- Liner: Kraft paper or PE-coated release liner
- Thickness: 1 mm-20 mm common range
- Format: Slit rolls, die-cut gaskets, kiss-cut parts
-


- Material: Closed-cell EVA foam
- Adhesive: Acrylic, rubber, or hot melt adhesive
- Color: Black, white, gray, or custom
- Thickness: 1 mm-15 mm typical range
- Width: 5 mm-1000 mm slit roll width
- Form: Rolls, strips, pads, die-cut gaskets
-


- Material: Closed-cell PE foam carrier
- Thickness: 0.5 mm-3.0 mm typical
- Density: 45-100 kg/m3 typical
- Color: White, black, gray optional
- Adhesive: Rubber, acrylic, solvent acrylic PSA
- Processing: Slitting, die-cutting, warm pressing, laminating
-


- Standard widths: 10mm, 15mm, 20mm, 25mm
- Color: Transparent
- Carrier material: Thin PET film (25 u)
- Adhesive type: Skin-safe acrylic layer, 80 u
- Application: Temporary fabric-to-fabric or fabric-to-skin fixing
- Peel adhesion: 0.8–1.2 N/cm (fabric-to-fabric), 0.5–0.9 N/cm (fabric-to-skin)
-


- Material: Transparent PU gel adhesive
- Color: Clear, high transparency
- Thickness: 0.5 mm, 1.0 mm, 2.0 mm, 3.0 mm
- Format: Roll, pad, strip, gasket
- Width: 10 mm-500 mm or slit to size
- Processing: Slitting, die cutting, kiss cutting
-

Closed cell EPDM foam properties are commonly compared through compression deflection, compression set, density, tensile strength, elongation, water absorption, and resistance to temperature, ozone, and weather. These values help screen grades for sealing, gasketing, cushioning, and adhesive-backed constructions. Read results with the stated test method and specimen condition, then confirm suitability on the intended surface, compression level, adhesive construction, and service environment.
-


- Width: 90 mm / 100 mm
- Length: 20 m / 50 m
- Color: Yellow, white, gold
- Adhesive: Heat activated hot melt
- Placement: Below carpet joint
- Use: Heat iron joining
-

Double sided tape for artificial grass can support turf-to-turf seaming, patch repair, light perimeter support and temporary turf-to-floor fixing, but these jobs create different bond lines. Selection should start with the actual turf backing, substrate, exposure, traffic and removal requirement rather than hand tack alone. Main risks include visible joints, edge lift, contaminated or damp contact surfaces, movement before adequate contact develops and adhesive transfer during removal. Where the surface, coating or outdoor condition is uncertain, a representative sample seam should be tested before full use.