No products were found matching your selection.
Other Related Products
-
- Material: PET/polyester film carrier with acrylic adhesive on both sides
- Color: Clear, translucent, black, or custom tinted film
- Thickness: 0.03 mm to 0.20 mm typical range
- Liner: Glassine paper, PE-coated paper, PET film, or double liner
- Format: Jumbo roll, slit roll, sheet, kiss-cut, or die-cut part
- Use: Nameplates, panels, overlays, membrane switches, and electronics
-
- Width: 90 mm / 100 mm
- Length: 20 m / 50 m
- Color: Yellow, white, gold
- Adhesive: Heat activated hot melt
- Placement: Below carpet joint
- Use: Heat iron joining
-
Double sided tape for artificial grass can support turf-to-turf seaming, patch repair, light perimeter support and temporary turf-to-floor fixing, but these jobs create different bond lines. Selection should start with the actual turf backing, substrate, exposure, traffic and removal requirement rather than hand tack alone. Main risks include visible joints, edge lift, contaminated or damp contact surfaces, movement before adequate contact develops and adhesive transfer during removal. Where the surface, coating or outdoor condition is uncertain, a representative sample seam should be tested before full use.
-
- Common thickness: 0.2 mm-5.0 mm
- Color: black, white, gray, or custom
- Carrier: PE foam, PU foam, EPDM, neoprene, or rubber
- Adhesive: acrylic PSA, rubber PSA, or differential PSA
- Liner: paper, PET, glassine, coated paper, or dual liner
- Supply form: rolls, sheets, kiss-cut parts, or die-cut gaskets
-
- Material: Transparent PU gel adhesive
- Color: Clear, high transparency
- Thickness: 0.5 mm, 1.0 mm, 2.0 mm, 3.0 mm
- Format: Roll, pad, strip, gasket
- Width: 10 mm-500 mm or slit to size
- Processing: Slitting, die cutting, kiss cutting
-
- Material: Closed-cell PVC foam carrier
- Colors: Black and white
- Adhesive: Acrylic or solvent acrylic PSA
- Liner: Blue film liner or paper liner
- Thickness: 0.8 mm-12.7 mm, custom available
- Supply: Slit rolls, master rolls, die-cut parts
-
Double sided acrylic tape shear strength describes resistance to a sustained load acting parallel to bonded surfaces. The value is meaningful only when bonded area, load, substrate, temperature, application pressure, dwell time, and failure criterion are stated. It explains static shear holding, how it differs from peel and tack, and when results are not comparable. Typical values and reference ranges should be confirmed by sample testing.
-
- Material: Cross-linked PE foam carrier
- Foam Type: IXPE foam with fine closed-cell structure
- Thickness: 0.5 mm-10 mm typical options
- Density: 25-100 kg/m3 for different compression needs
- Color: Black, white, grey
- Use: Gasket, spacer, sealing, cushioning, die-cut parts
-
- Common Size: jumbo rolls, slit rolls, die-cut pads, strips, and laminated sheets.
- Color: white, black, grey, or custom foam color.
- Material: PE, EVA, IXPE, or PU foam carrier.
- Adhesive: acrylic, rubber, or hot melt PSA on both sides.
- Thickness: 0.3 mm to 3.0 mm typical range.
- Use: panel bonding, nameplate mounting, molding fixing, and converter processing.
