No products were found matching your selection.
Other Related Products
-
- Material: Closed-cell EVA foam
- Adhesive: Acrylic, rubber, or hot melt adhesive
- Color: Black, white, gray, or custom
- Thickness: 1 mm-15 mm typical range
- Width: 5 mm-1000 mm slit roll width
- Form: Rolls, strips, pads, die-cut gaskets
-
Double sided acrylic tape shear strength describes resistance to a sustained load acting parallel to bonded surfaces. The value is meaningful only when bonded area, load, substrate, temperature, application pressure, dwell time, and failure criterion are stated. It explains static shear holding, how it differs from peel and tack, and when results are not comparable. Typical values and reference ranges should be confirmed by sample testing.
-
- Material: Transparent PU gel adhesive
- Color: Clear, high transparency
- Thickness: 0.5 mm, 1.0 mm, 2.0 mm, 3.0 mm
- Format: Roll, pad, strip, gasket
- Width: 10 mm-500 mm or slit to size
- Processing: Slitting, die cutting, kiss cutting
-
- Standard widths: 10mm, 15mm, 20mm, 25mm
- Color: Transparent
- Carrier material: Thin PET film (25 u)
- Adhesive type: Skin-safe acrylic layer, 80 u
- Application: Temporary fabric-to-fabric or fabric-to-skin fixing
- Peel adhesion: 0.8–1.2 N/cm (fabric-to-fabric), 0.5–0.9 N/cm (fabric-to-skin)
-
Double sided tape for artificial grass can support turf-to-turf seaming, patch repair, light perimeter support and temporary turf-to-floor fixing, but these jobs create different bond lines. Selection should start with the actual turf backing, substrate, exposure, traffic and removal requirement rather than hand tack alone. Main risks include visible joints, edge lift, contaminated or damp contact surfaces, movement before adequate contact develops and adhesive transfer during removal. Where the surface, coating or outdoor condition is uncertain, a representative sample seam should be tested before full use.
-
- Common thickness: 0.4 mm, 0.6 mm, 0.8 mm, 1.0 mm, 1.2 mm, 1.5 mm
- Color: black, gray, white, or custom foam color
- Foam carrier: closed-cell PE foam or acrylic foam option
- Adhesive: automotive-grade acrylic pressure-sensitive adhesive
- Liner: red PE film, white paper, or easy-release film liner
- Typical tolerance: +/-05 mm thickness, +/-0.5 mm slitting reference
-
- Material: Closed-cell neoprene foam
- Color: Black as standard
- Adhesive: Rubber PSA or acrylic PSA
- Liner: Kraft paper or PE-coated release liner
- Thickness: 1 mm-20 mm common range
- Format: Slit rolls, die-cut gaskets, kiss-cut parts
-
- Material: NBR/PVC flexible elastomeric foam
- Foam Structure: Closed-cell
- Color: Black
- Common Thickness: 3 mm, 5 mm, 6 mm
- Common Width: 25 mm, 50 mm, 75 mm
- Adhesive: Pressure-sensitive adhesive with release liner
-
- Width: 10 mm-50 mm
- Thickness: 1 mm-5 mm
- Color: Black, grey, custom
- Backing: Heat resistant fiber composite
- Adhesive: High temperature self adhesive backing
- Use Area: Lid edge, door gap, window edge
