No products were found matching your selection.
Other Related Products
-
- Material: PET/polyester film carrier with acrylic adhesive on both sides
- Color: Clear, translucent, black, or custom tinted film
- Thickness: 0.03 mm to 0.20 mm typical range
- Liner: Glassine paper, PE-coated paper, PET film, or double liner
- Format: Jumbo roll, slit roll, sheet, kiss-cut, or die-cut part
- Use: Nameplates, panels, overlays, membrane switches, and electronics
-
- Common thickness: 1/8 inch, 1/4 inch, 3/8 inch, 1/2 inch, 3/4 inch, 1 inch
- Color: gray, charcoal gray, or custom dark foam appearance
- Material: open-cell polyether urethane foam
- Adhesive option: rubber PSA, acrylic PSA, single sided, double sided, or plain foam
- Supply form: slit rolls, sheets, kiss-cut pads, and die-cut parts
- Main use: cushioning, gasketing, sound damping, light blocking, and vibration control
-
- Material: Closed-cell EVA foam
- Adhesive: Acrylic, rubber, or hot melt adhesive
- Color: Black, white, gray, or custom
- Thickness: 1 mm-15 mm typical range
- Width: 5 mm-1000 mm slit roll width
- Form: Rolls, strips, pads, die-cut gaskets
-
- Standard widths: 10mm, 15mm, 20mm, 25mm
- Color: Transparent
- Carrier material: Thin PET film (25 u)
- Adhesive type: Skin-safe acrylic layer, 80 u
- Application: Temporary fabric-to-fabric or fabric-to-skin fixing
- Peel adhesion: 0.8–1.2 N/cm (fabric-to-fabric), 0.5–0.9 N/cm (fabric-to-skin)
-
- Material: Closed-cell PE foam carrier
- Thickness: 0.5 mm-3.0 mm typical
- Density: 45-100 kg/m3 typical
- Color: White, black, gray optional
- Adhesive: Rubber, acrylic, solvent acrylic PSA
- Processing: Slitting, die-cutting, warm pressing, laminating
-
Double sided acrylic tape shear strength describes resistance to a sustained load acting parallel to bonded surfaces. The value is meaningful only when bonded area, load, substrate, temperature, application pressure, dwell time, and failure criterion are stated. It explains static shear holding, how it differs from peel and tack, and when results are not comparable. Typical values and reference ranges should be confirmed by sample testing.
-
- Width: 10 mm-50 mm
- Thickness: 1 mm-5 mm
- Color: Black, grey, custom
- Backing: Heat resistant fiber composite
- Adhesive: High temperature self adhesive backing
- Use Area: Lid edge, door gap, window edge
-
- Common Width: 10 cm, 15 cm, 20 cm
- Common Length: 5 m, 10 m, 15 m, 20 m, 50 m
- Color: Green, black, white liner, custom available
- Backing Material: Non-woven fabric or PP cloth
- Adhesive Type: Hot melt pressure-sensitive adhesive
- Use Area: Backing-side artificial grass seam connection
-
Double sided tape for artificial grass can support turf-to-turf seaming, patch repair, light perimeter support and temporary turf-to-floor fixing, but these jobs create different bond lines. Selection should start with the actual turf backing, substrate, exposure, traffic and removal requirement rather than hand tack alone. Main risks include visible joints, edge lift, contaminated or damp contact surfaces, movement before adequate contact develops and adhesive transfer during removal. Where the surface, coating or outdoor condition is uncertain, a representative sample seam should be tested before full use.
