No products were found matching your selection.
Other Related Products
-
- Material: Closed-cell neoprene foam
- Color: Black as standard
- Adhesive: Rubber PSA or acrylic PSA
- Liner: Kraft paper or PE-coated release liner
- Thickness: 1 mm-20 mm common range
- Format: Slit rolls, die-cut gaskets, kiss-cut parts
-
- Common thickness: 1/8 inch, 1/4 inch, 3/8 inch, 1/2 inch, 3/4 inch, 1 inch
- Color: gray, charcoal gray, or custom dark foam appearance
- Material: open-cell polyether urethane foam
- Adhesive option: rubber PSA, acrylic PSA, single sided, double sided, or plain foam
- Supply form: slit rolls, sheets, kiss-cut pads, and die-cut parts
- Main use: cushioning, gasketing, sound damping, light blocking, and vibration control
-
- Common size: 2-20 mm thickness, custom slit width
- Color: Black EPDM foam with protected adhesive side
- Material: Closed-cell EPDM foam carrier
- Adhesive: One-sided pressure sensitive backing
- Liner: Peel-off paper or film release liner
- Use: Sealing, cushioning, gap filling
-
Double sided acrylic tape shear strength describes resistance to a sustained load acting parallel to bonded surfaces. The value is meaningful only when bonded area, load, substrate, temperature, application pressure, dwell time, and failure criterion are stated. It explains static shear holding, how it differs from peel and tack, and when results are not comparable. Typical values and reference ranges should be confirmed by sample testing.
-
- Material: Cross-linked PE foam carrier
- Foam Type: IXPE foam with fine closed-cell structure
- Thickness: 0.5 mm-10 mm typical options
- Density: 25-100 kg/m3 for different compression needs
- Color: Black, white, grey
- Use: Gasket, spacer, sealing, cushioning, die-cut parts
-
- Material: Closed-cell EVA foam
- Adhesive: Acrylic, rubber, or hot melt adhesive
- Color: Black, white, gray, or custom
- Thickness: 1 mm-15 mm typical range
- Width: 5 mm-1000 mm slit roll width
- Form: Rolls, strips, pads, die-cut gaskets
-
Double sided tape for artificial grass can support turf-to-turf seaming, patch repair, light perimeter support and temporary turf-to-floor fixing, but these jobs create different bond lines. Selection should start with the actual turf backing, substrate, exposure, traffic and removal requirement rather than hand tack alone. Main risks include visible joints, edge lift, contaminated or damp contact surfaces, movement before adequate contact develops and adhesive transfer during removal. Where the surface, coating or outdoor condition is uncertain, a representative sample seam should be tested before full use.
-
- Material: Closed-cell PE foam carrier
- Thickness: 0.5 mm-3.0 mm typical
- Density: 45-100 kg/m3 typical
- Color: White, black, gray optional
- Adhesive: Rubber, acrylic, solvent acrylic PSA
- Processing: Slitting, die-cutting, warm pressing, laminating
